CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the intake air control valve actuator (for TCV) removal/installation are shown below.
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Drive the vehicle until stop and start control is permitted (approximately 15 to 40 minutes) | Stop and start system | |
| Memorize steering angle neutral point | Panoramic view monitor system | ||
| Initialize back door lock | Power door lock control system | ||
| Initialize servo motor | Air conditioning system | ||
| Reset slide door close position | Power slide door system | ||
| Reset back door close position | Power back door system | ||
| Throttle body with motor assembly | Inspection After Repair |
|
|
| Cleaning the deposits from the throttle body with motor assembly |
PROCEDURE
- Click here
REMOVE INTAKE MANIFOLD
- Click here
REMOVE INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)
-
Remove the 2 bolts and intake air control valve actuator (for TCV) from the intake manifold.
Note:
-
Make sure that foreign matter, such as water, oil, sand or iron particles, does not enter the gear chamber or intake air control valve actuator (for TCV) at the locations marked by the circles in the illustration.
-
Do not loosen or remove the bolt or 2 nuts shown in the illustration.
-
-
Remove the gasket from the intake air control valve actuator (for TCV).
-