Click here

ДЕМПФЕР ПУЛЬСАЦИЙ ДАВЛЕНИЯ В ТОПЛИВНОЙ СИСТЕМЕ УСТАНОВКА

Click here
Click here Click here

PROCEDURE


  1. Click here

    INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    1. Apply a light coat of gasoline or spindle oil to a new O-ring.

    2. Install the O-ring to the fuel pressure pulsation damper assembly.

    3. Install the fuel pressure pulsation damper assembly to the fuel delivery pipe with the 2 bolts.

      10 N*m 102 kgf*cm 7 ft.*lbf
      Note:

      Make sure that the O-ring is not cracked or jammed when installing the fuel pressure pulsation damper assembly.

  2. Click here

    CONNECT FUEL TUBE SUB-ASSEMBLY

    Note:

    Check that there is no damage or foreign matter on the connecting parts of the fuel lines.


    1. A01UCFQC01
      *1 Fuel Tube Sub-assembly
      *a Retainer
      *b O-ring
      *c Nylon Tube
      *d Fuel Tube Connector
      *e Fuel Pipe
      A01UFKZ Push

      Connect the fuel tube sub-assembly to the fuel delivery pipe.


      1. Align the fuel tube connector with the fuel pipe, and push the fuel pipe into the fuel tube connector until the fuel tube connector makes a "click" sound. If it is difficult to push the fuel pipe into the fuel tube connector, apply a small amount of clean gasoline to the tip of the fuel pipe.

      2. After connecting the fuel lines, check that the fuel pipe and fuel tube connector are securely connected by pulling on them.

      3. Engage the clamp to connect the fuel tube sub-assembly to the fuel hose clamp.

    2. Type A:


      1. Install the No. 2 fuel pipe clamp.

    3. Type B:


      1. Engage the 2 claws to install a new No. 2 fuel pipe clamp.

  3. Click here

    INSTALL AIR CLEANER HOSE ASSEMBLY

    Click here

  4. Click here

    INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  5. Click here

    INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  6. Click here

    INSTALL BATTERY

    Click here

  7. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  8. Click here

    INSTALL CENTER NO. 1 COWL TOP VENTILATOR LOUVER

    Click here

  9. Click here

    INSPECT FOR FUEL LEAK

    Click here