ДВИГАТЕЛЬ В СБОРЕ УЗЛЫ И ДЕТАЛИ
ILLUSTRATION
| *1 | FRONT LOWER BUMPER ABSORBER | *2 | NO. 1 ENGINE UNDER COVER |
| *3 | NO. 2 ENGINE UNDER COVER | *4 | REAR ENGINE UNDER COVER LH |
| *5 | REAR ENGINE UNDER COVER RH | - | - |
ILLUSTRATION
| *1 | AIR CLEANER HOSE ASSEMBLY | *2 | BATTERY CARRIER |
| *3 | BATTERY CARRIER SUPPORT | *4 | NO. 2 WATER BY-PASS HOSE |
| *5 | GENERATOR ASSEMBLY | *6 | NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
| *7 | NO. 1 COOLER REFRIGERANT SUCTION HOSE | *8 | RADIATOR RESERVE TANK ASSEMBLY |
| *9 | RADIATOR RESERVE TANK BRACKET | *10 | TRANSMISSION CONTROL CABLE ASSEMBLY |
| *11 | V-RIBBED BELT | *12 | O-RING |
| *13 | WATER BY-PASS HOSE | *14 | TERMINAL CAP |
| *15 | PURGE VALVE (PURGE VSV) | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Compressor oil ND-OIL 8 or equivalent | - | - |
ILLUSTRATION
| *1 | ENGINE WIRE | *2 | FUEL TUBE SUB-ASSEMBLY |
| *3 | NO. 1 FUEL VAPOR FEED HOSE | *4 | NO. 1 RADIATOR HOSE |
| *5 | NO. 2 RADIATOR HOSE | *6 | UNION TO CHECK VALVE HOSE |
| *7 | RADIATOR HOSE CLAMP | *8 | NO. 2 WATER BY-PASS HOSE |
| *9 | WATER HOSE SUB-ASSEMBLY | *10 | HEATER WATER INLET HOSE |
| *11 | NO. 1 RELAY BLOCK COVER | *12 | NO. 3 ENGINE WIRE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | COLUMN HOLE COVER SILENCER SHEET | *2 | FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) |
| *3 | NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY | *4 | EXHAUST PIPE GASKET |
| *5 | COMPRESSION SPRING | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | ENGINE ASSEMBLY WITH TRANSAXLE | *2 | ENGINE MOUNTING INSULATOR LH |
| *3 | ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH | *4 | ENGINE WIRE |
| *5 | FRONT ENGINE MOUNTING INSULATOR | *6 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY |
| *7 | FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY LH | *8 | FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY RH |
| *9 | FRONT SUSPENSION MEMBER REINFORCEMENT LH | *10 | FRONT SUSPENSION MEMBER REINFORCEMENT RH |
| *11 | NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY | *12 | REAR ENGINE MOUNTING INSULATOR |
| *13 | FRONT CROSSMEMBER SUB-ASSEMBLY | *14 | BRACKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | BREATHER PLUG HOSE | *2 | CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY |
| *3 | DRIVE PLATE AND RING GEAR SUB-ASSEMBLY | *4 | DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT |
| *5 | FLYWHEEL HOUSING UNDER COVER | *6 | FRONT ENGINE MOUNTING BRACKET |
| *7 | STARTER ASSEMBLY | *8 | FRONT DRIVE PLATE SPACER |
| *9 | REAR DRIVE PLATE SPACER | *10 | NO. 2 ENGINE WIRE |
| *11 | TERMINAL CAP | - | - |
| *a | BLACK COLOR: x 1 SILVER COLOR: x 5 |
- | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | |
Adhesive 1324 |
| ★ | Precoated part | - | - |
| *T1 | Bolt Length 32 mm (1.26 in.): 44 (449, 32) Bolt Length 33 mm (1.30 in.): 43 (438, 32) |
- | - |