ПОДОГРЕВАЕМЫЙ КИСЛОРОДНЫЙ ДАТЧИК СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  2. REMOVE HEATED OXYGEN SENSOR


    1. A01IIDXN01

      Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST
      09224-00011

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.