ДАТЧИК СОСТАВА ТОПЛИВОВОЗДУШНОЙ СМЕСИ УСТАНОВКА

PROCEDURE

1. Click here

   INSTALL AIR FUEL RATIO SENSOR

   Tip:

   Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

   Click here

   
   
   1. 

      *a	Torque Wrench Fulcrum Length

      Using SST, install the air fuel ratio sensor to the exhaust manifold.

      09224-00011

      Specified tightening torque
      44 N*m	449 kgf*cm	32 ft.*lbf

      Note:

      If the air fuel ratio sensor has been struck or dropped, replace it.

      Tip:
      

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 260 mm (10.2 in.)):

        39 N*m (398 kgf*cm, 29 ft.*lbf)

   2. Connect the air fuel ratio sensor connector.

   3. Install the air fuel ratio sensor wire to the No. 1 radiator hose and engage the hose clamp.

2. Click here

   INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

   Click here

3. Click here

   INSPECT FOR EXHAUST GAS LEAK

   Click here

4. Click here

   PERFORM INITIALIZATION

   
   

   1. Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

      Click here