INITIALIZATION
Perform Registration (VIN registration or frame number registration) when replacing the ECM.
Before replacing the ECM, refer to Service Bulletin (for Immobiliser System).
Make sure to perform Reset Memory (CVT initialization), deceleration sensor zero point calibration and CVT oil pressure calibration when replacing the ECM or the oil pressure sensor.
When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Stop and Start System | |
| Panoramic View Monitor System | |
| Power Door Lock Control System | |
| Air Conditioning System | |
| Power Slide Door System | |
| Power Back Door System |
When replacing the engine stop and start ECU with a new one, make sure to download the previous status (number of starter operations) of the old engine stop and start ECU.
When the starter assembly is replaced, the number of starter operations stored in the engine stop and start ECU must be reset.
WHEN USING GTS
Observe the following items for safety reasons:
Before using the GTS, read the instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes using the GTS, 2 persons are required. One is for driving the vehicle, and the other operates the GTS.