ACTIVE REAR WING SWITCH INSPECTION

PROCEDURE

1. *a Indicator Light *b Illumination *c Component without harness connected (Spoiler Control Switch)
   Click here

   INSPECT SPOILER CONTROL SWITCH

   
   

   1. Check the switch.

      
      

      1. Measure the resistance according to the value(s) in the table below.

         Standard Resistance
         Tester Connection Condition Specified Condition 3 - 6 Spoiler control switch pressed Below 1 Ω Spoiler control switch not pressed 10 kΩ or higher

         If the result is not as specified, replace the spoiler control switch.

   2. Check the switch illumination and indicator light.

      
      

      1. Apply battery voltage to the spoiler control switch and check that the switch illumination and indicator light illuminates.

         OK
         Battery Connection Specified Condition Battery positive (+) → 2 Battery negative (-) → 7 Indicator light illuminates Battery positive (+) → 5 Battery negative (-) → 4 Illumination illuminates

         If the result is not as specified, replace the spoiler control switch.