Click here

WHEEL OPENING MOULDING REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    REMOVE REAR BUMPER SIDE MOULDING SUB-ASSEMBLY


    1. A01FMXDC01
      B00667M Protective Tape

      Apply protective tape around the rear bumper side moulding sub-assembly as shown in the illustration.

    2. Remove the outside moulding retainer.

    3. A01FP06C01
      *a Double-sided Tape

      Using a moulding remover, separate the double-sided tape and disengage the 2 guides to remove the rear bumper side moulding sub-assembly.