ROOF DRIP SIDE FINISH MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING

    Tech Tips

    When removing the center roof drip side finish moulding, heat the vehicle body and center roof drip side finish moulding using a heat light.

    Heating Temperature
    Item Temperature
    Vehicle Body 40 to 60°C (104 to 140°F)
    Center Roof Drip Side Finish Moulding 20 to 30°C (68 to 86°F)

    Note

    Do not heat the vehicle body or center roof drip side finish moulding excessively.


    1. Using a heat light, heat the center roof drip side finish moulding.

    2. Apply protective tape around the center roof drip side finish moulding as shown in the illustration.

      A01FMDZC01
      B00667M Protective Tape - -

    3. Using a moulding remover, disengage the 11 No. 1 roof drip side finish moulding clips and remove the center roof drip side finish moulding.

      Note


      • Do not remove the No. 1 roof drip side finish moulding clips.

      • If any No. 1 roof drip side finish moulding clip is damaged or falls out, replace it with a new one.