Click here

ROCKER PANEL MOULDING REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    REMOVE FRONT REAR WHEEL HOUSE PLATE

    Click here

  2. Click here

    REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY


    1. A01FNS3C01
      B00667M Protective Tape - -

      Apply protective tape around the body rocker panel moulding assembly and door as shown in the illustration.

    2. A01FKLS

      Remove the 3 screws.

    3. Using a clip remover, remove the 2 clips.

    4. A01FKW4

      Remove the screw.

    5. A01FLJAC01
      B00667M Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the rear rocker panel moulding end cover.

      Tip:

      Use the same procedure for the other rear rocker panel moulding end cover.

    6. A01FLPK

      Using a clip remover, remove the 6 clips.

    7. Remove the 2 screws.

    8. A01FK77

      Disengage the 14 clips to remove the body rocker panel moulding assembly.

    9. Remove the 14 clips from the body rocker panel moulding assembly.