FRONT DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  4. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  6. REMOVE DOOR TRIM COVER

    Click here

  7. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  8. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  10. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click here

  11. REMOVE FRONT DOOR TRIM BRACKET

    Click here

  12. REMOVE OUTER MIRROR INSTALL HOLE COVER

    Click here

  13. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  14. REMOVE FRONT DOOR UPPER WINDOW STOP

    Click here

  15. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  16. REMOVE FRONT DOOR FRONT LOWER FRAME UPPER COVER

    Click here

  17. DISCONNECT FRONT DOOR WEATHERSTRIP


    1. B006884

      Using a clip remover, disengage the 2 clips and disconnect the front door weatherstrip.

  18. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY


    1. B006840C01
      B00667M Protective Tape

      Apply protective tape around the front door belt moulding assembly as shown in the illustration.

    2. B0066Y5C01
      *a Screwdriver
      B00667M Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 7 claws and remove the front door belt moulding assembly.