FRONT BUMPER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

PROCEDURE


  1. INSTALL FRONT BUMPER ASSEMBLY


    1. w/ Headlight Cleaner System:


      1. B0065W6

        Connect the washer hose to drain the washer fluid.

    2. B006757

      Engage the 6 guides as shown in the illustration.

    3. Pull back the side of the front bumper assembly and connect the 2 connectors.

      Note

      Do not apply excessive force when pulling back the front bumper assembly.

    4. B00678P

      Engage the 3 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    5. Install the 2 clips.

    6. Install the 3 bolts.

    7. Install the 8 screws.

    8. Install the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    9. B0065G0C01
      *1 Pin Hold Clip
      *a Correct
      *b Incorrect

      Install the front bumper assembly with the pin hold clip as shown in the illustration.

      Note

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    10. w/ Pre-collision System:


      1. Connect the connector.

  2. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 10 clips.

  3. ADD WINDSHIELD WASHER FLUID (w/ Headlight Cleaner System)

    Click here