RELAY ON-VEHICLE INSPECTION

PROCEDURE

1. Click here

   INSPECT HORN RELAY ASSEMBLY

   
   
   1. 

      *a	Component without harness connected (HORN Relay)

      Remove the HORN relay.

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher 3 - 5 Battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the HORN relay.