| DTC Code | DTC Name |
|---|---|
| B1318 | Short in Manual Switch Circuit |
DESCRIPTION
This DTC is stored when the spoiler control switch is determined to be stuck on or there is a short in the spoiler control switch circuit.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1318 | Short in Manual Switch Circuit | When voltage at terminal ECUB of the spoiler control ECU assembly is 9 V or more, the spoiler control switch is stuck on for 30 seconds or more. |
|
WIRING DIAGRAM
PROCEDURE
READ VALUE USING GTS
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Active Rear Wing / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Manual Switch | Spoiler control switch condition | OFF or ON | OFF: Spoiler control switch not pressed ON: Spoiler control switch pressed |
- |
| Tester Display |
|---|
| Manual Switch |
| OK |
|---|
| The GTS display changes according to the spoiler control switch. |
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE SPOILER CONTROL ECU ASSEMBLY Click here |
| OK |
|
INSPECT SPOILER CONTROL SWITCH
Remove the spoiler control switch.
Inspect the spoiler control switch.
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE SPOILER CONTROL SWITCH Click here |
| OK |
|
CHECK HARNESS AND CONNECTOR (SPOILER CONTROL ECU ASSEMBLY - SPOILER CONTROL SWITCH)
Disconnect the U38 spoiler control ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| OK |
|
REPLACE SPOILER CONTROL ECU ASSEMBLY Click here |
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |