Click here

CLEARANCE LIGHT ASSEMBLY INSPECTION

Click here
Click here

PROCEDURE


  1. Click here

    INSPECT CLEARANCE LIGHT HOUSING ASSEMBLY LH


    1. Remove the clearance light assembly LH.

      Click here

    2. Remove the clearance housing assembly LH from the clearance assembly LH.

      Click here

    3. B00683EC09
      *a

      Component without harness connected

      (Clearance Light Housing Assembly LH)

      		 - -

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D4-1 (B) - A-5 Always Below 1 Ω
      D4-2 (E) - A-2 Always Below 1 Ω
      D4-3 (DRL) - A-4 Always Below 1 Ω
      D4-4 (DRLC) - A-3 Always Below 1 Ω

      If the result is not as specified, replace the clearance light assembly LH.

  2. Click here

    INSPECT CLEARANCE LIGHT ASSEMBLY LH


    1. A01FKPXC03
      *a

      Component without harness connected

      (Clearance Light Assembly LH)

      Apply battery voltage to the clearance light assembly LH and check the light comes on.

      OK
      Condition Specified Condition

      Battery positive (+) → 3 (DRL)

      Battery negative (-) → 2 (E) and 4 (DRLC)

      		 Light comes on

      Battery positive (+) → 1 (B)

      Battery negative (-) → 2 (E)

      		 Light comes on

      If the result is not as specified, replace the clearance light LED unit assembly LH.

  3. Click here

    INSPECT CLEARANCE LIGHT HOUSING ASSEMBLY RH


    1. Remove the clearance light assembly RH.

      Click here

    2. Remove the clearance housing assembly RH from the clearance assembly RH.

      Click here

    3. A01FNBUC09
      *a

      Component without harness connected

      (Clearance Light Housing Assembly RH)

      		 - -

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D2-1 (B) - A-5 Always Below 1 Ω
      D2-2 (E) - A-2 Always Below 1 Ω
      D2-3 (DRL) - A-4 Always Below 1 Ω
      D2-4 (DRLC) - A-3 Always Below 1 Ω

      If the result is not as specified, replace the clearance light assembly RH.

  4. Click here

    INSPECT CLEARANCE LIGHT ASSEMBLY RH


    1. A01FKPXC04
      *a

      Component without harness connected

      (Clearance Light Assembly RH)

      Apply battery voltage to the clearance light assembly RH and check the light comes on.

      OK
      Condition Specified Condition

      Battery positive (+) → 3 (DRL)

      Battery negative (-) → 2 (E) and 4 (DRLC)

      		 Light comes on

      Battery positive (+) → 1 (B)

      Battery negative (-) → 2 (E)

      		 Light comes on

      If the result is not as specified, replace the clearance light LED unit assembly RH.