Click here

REAR TURN SIGNAL LIGHT BULB REPLACEMENT

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    REMOVE REAR LIGHT COVER


    1. A01FMB9C01
      B00667M Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws to remove the 2 rear light covers.

  2. Click here

    DISCONNECT REAR COMBINATION LIGHT ASSEMBLY


    1. A01FNT9C01
      B00667M Protective Tape

      Apply protective tape around the rear combination light assembly as shown in the illustration.

    2. Remove the 2 screws.

    3. A01FKWOC01
      *a Pin *b Guide

      Push the rear combination light assembly at the portion (A) toward the rear of the vehicle to disengage the pin and 3 guides to separate the rear combination light assembly as shown in the illustration.

      Note:

      To prevent the rear combination light assembly from falling when disengaging the pin and 3 guides, lightly hold the rear combination light assembly.

      Tip:

      Pushing on the portion (A) will make disengagement of the pin easier.

  3. Click here

    REMOVE REAR TURN SIGNAL LIGHT BULB


    1. A01FNYY

      Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.

    2. A01FKEH

      Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.

  4. Click here

    INSTALL REAR TURN SIGNAL LIGHT BULB


    1. A01FKEH

      Install a new rear turn signal light bulb to the rear combination light socket and wire sub-assembly.

    2. A01FKIW

      Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to connect them as a unit.

  5. Click here

    INSTALL REAR COMBINATION LIGHT ASSEMBLY


    1. A01FNGZC02
      *a Pin *b Guide

      Engage the 3 guides and pin to temporarily install the rear combination light assembly as shown in the illustration.

    2. A01FNT9

      Install the rear combination light assembly with the 2 screws.

      2.3 N*m 23 kgf*cm 20 in.*lbf

    3. Remove the protective tape.

  6. Click here

    INSTALL REAR LIGHT COVER


    1. A01FOB0

      Engage the 6 claws to install the 2 rear light covers.