FUEL LID OPENER UNIT

PROCEDURE

Click here
PRECAUTION

Click here
Click here
REMOVE FUEL FILLER OPENING LID LOCK SUB-ASSEMBLY

Click here
Click here
REMOVE REAR WHEEL LH

Click here
Click here
REMOVE FRONT REAR WHEEL HOUSE PLATE

Click here
Click here
REMOVE REAR WHEEL HOUSE LINER LH
1. Remove the screw.
2. Remove the clip.
3. Remove the clip.
4. Remove the clip.
5. Remove the 4 grommets.
  
  Tip:
  The grommets need to be replaced with new ones because they will break when they are removed.
6. Remove the 8 nuts and rear wheel house liner LH.
  
  Tip:
  Depending on the vehicle, resin nuts (clips) may be used.
Click here
REMOVE FUEL FILLER OPENING LID ASSEMBLY
1. Protective Tape
  
  Apply protective tape around the fuel filler opening lid sub-assembly as shown in the illustration.
2. Protective Tape
  
  Using a screwdriver with its tip wrapped with protective tape, disengage the claw.
3. Slide the fuel filler opening lid assembly to disconnect it from the 4 parts (a) and remove it as shown in the illustration.
Click here
REMOVE FUEL TANK CAP ASSEMBLY
1. Remove the fuel tank cap assembly as shown in the illustration.
2. Disengage the clamp to remove the fuel tank cap assembly.

REMOVE FUEL FILLER OPENING LID SUB-ASSEMBLY

*1 Fuel Inlet Box Ring - -

Remove the fuel inlet box ring as shown in the illustration.
Remove the fuel tank filler pipe shield as shown in the illustration.
Remove the 4 screws.
Remove the fuel filler opening lid sub-assembly as shown in the illustration.

*1	Fuel Inlet Box Ring	-	-
*a	Push	*b	Pull

Push the fuel tank filler pipe shield and fuel inlet box ring as shown in the illustration.

Pull the fuel tank filler pipe shield and fuel inlet box ring as shown in the illustration to remove them as a set.
*1 Fuel Inlet Box Ring

Remove the fuel inlet box ring.

FUEL LID OPENER UNIT REMOVAL