LUGGAGE COMPARTMENT DOOR OPENER OUTER SWITCH INSPECTION

PROCEDURE

1. Click here

   INSPECT LUGGAGE ELECTRICAL KEY SWITCH

   
   

   1. Check the resistance of the switch.

      
      
      1. 

         *a	Component without harness connected (Luggage Electrical Key Switch)

         Measure the resistance according to the value(s) in the table below.

         Standard Resistance
         Tester Connection Condition Specified Condition 5 (UL) - 10 (E) Switch not pressed 10 kΩ or higher Switch pressed Below 1 Ω

         If the result is not as specified, replace the luggage electrical key switch.

   2. Check the resistance of the harness.

      
      
      1. 

         *a

         Luggage Electrical Key Switch (Wire Harness Side)

         *b

         Luggage Electrical Key Switch (Rear Television Camera Assembly Side)

         Measure the resistance according to the value(s) in the table below.

         Standard Resistance
         Tester Connection Condition Specified Condition U40-6 (CB+) - A-6 (CB+) Always Below 1 Ω U40-7 (CV+) - A-3 (CV+) Always Below 1 Ω U40-2 (CV-) - A-2 (CV-) Always Below 1 Ω U40-1 (CGND) - A-5 (CGND) Always Below 1 Ω U40-4 (CURT) - A-1 (CURT) Always Below 1 Ω

         If the result is not as specified, replace the luggage electrical key switch.