Click here

HOOD ADJUSTMENT

Click here
*a Centering Bolt *b Standard Bolt
Click here

CAUTION / NOTICE / HINT

Tip:

  • Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

  • Specified torque for standard bolts is shown in the standard bolt chart.

    Click here

Click here

PROCEDURE


  1. Click here

    INSPECT HOOD SUB-ASSEMBLY

    Click here

  2. Click here

    ADJUST HOOD SUB-ASSEMBLY


    1. Horizontally and vertically adjust the hood.


      1. B0067P2

        Loosen the 4 hinge bolts of the hood.

      2. Adjust the clearance between the hood and front fender by moving the hood.

      3. Tighten the 4 hinge bolts after adjustment.

        13 N*m 133 kgf*cm 10 ft.*lbf

    2. Adjust the height of the front end of the hood using the hood bumper cushions.


      1. B0066GR

        Adjust the 2 hood bumper cushions so that the heights of the hood and fenders are aligned.

        Tip:

        Raise or lower the front end of the hood by turning the 2 hood bumper cushions.

    3. Adjust the hood lock.


      1. Remove the cool air intake duct seal.

        Click here

      2. Remove the hood lock release lever protector.

        Click here

      3. B0066A9

        Loosen the 3 bolts.

      4. Adjust the hood lock and tighten the 3 bolts.

        7.5 N*m 76 kgf*cm 66 in.*lbf

      5. Check that the striker can engage the hood lock smoothly.

      6. Install the hood lock release lever protector.

        Click here

      7. Install the cool air intake duct seal.

        Click here