Click here

SLIDING ROOF SYSTEM DATA LIST / ACTIVE TEST

Click here
Click here
Click here

  1. DATA LIST

    Tip:

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note:

    In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Sliding Roof or Main Body / Data List.

    5. Read the Data List according to the display on the GTS.


      1. Body Electrical > Sliding Roof > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Open Switch OPEN switch signal OFF or ON

        OFF: OPEN switch not pressed

        ON: OPEN switch pressed

        		 -
        Close Switch CLOSE switch signal OFF or ON

        OFF: CLOSE switch not pressed

        ON: CLOSE switch pressed

        		 -
        Up Switch UP switch signal OFF or ON

        OFF: UP switch not pressed

        ON: UP switch pressed

        		 -
        Down Switch DOWN switch signal OFF or ON

        OFF: DOWN switch not pressed

        ON: DOWN switch pressed

        		 -
        Front SW Auto Operation Sliding roof auto function OFF or ON Customize setting displayed -
        Hall IC1 Pulse Hall IC1 pulse output Lo or Hi Lo and Hi repeat during motor operation

        Lo: Hall IC1 output is low

        Hi: Hall IC1 output is high
        Hall IC1 Status Status of Hall IC1 Normal or Error

        Normal: Hall IC1 normal

        Error: Hall IC1 not normal

        		 -
        Hall IC2 Pulse Hall IC2 pulse output Lo or Hi Lo and Hi repeat during motor operation

        Lo: Hall IC2 output is low

        Hi: Hall IC2 output is high
        Hall IC2 Status Status of Hall IC2 Normal or Error

        Normal: Hall IC2 normal

        Error: Hall IC2 not normal

        		 -
        Ignition (Direct Signal) Engine switch signal OFF or ON

        OFF: Engine switch off

        ON: Engine switch on (IG)

        		 -
        Ignition (MPX) Engine switch signal (LIN signal) OFF or ON

        OFF: Engine switch off

        ON: Engine switch on (IG)

        		 -
        Door Courtesy Driver door courtesy light switch signal OFF or ON

        OFF: Driver door closed

        ON: Driver door open

        		 -
        Door Key Close Operation Key-linked sliding roof close signal OFF or ON

        OFF: Driver door key cylinder not turned

        ON: Driver door key cylinder turned and held at the lock position

        		 -
        Door Key Open Operation Key-linked sliding roof open signal OFF or ON

        OFF: Driver door key cylinder not turned

        ON: Driver door key cylinder turned and held at the unlock position

        		 -
        Wireless Close Operation Wireless transmitter-linked sliding roof close signal* OFF or ON

        OFF: Transmitter LOCK switch not pressed

        ON: Transmitter LOCK switch pressed and held

        		 -
        Wireless Open Operation Wireless transmitter-linked sliding roof open signal* OFF or ON

        OFF: Transmitter UNLOCK switch not pressed

        ON: Transmitter UNLOCK switch pressed and held

        		 -
        Key Off Permission Key-off sliding roof operation permit signal OFF or ON

        OFF: Any status except "ON" status

        ON: Front doors are not opened within 43 seconds after engine switch turned off

        		 -
        Open Switch Failure(Past) Open switch failure signal (Past) OFF or ON

        OFF: No sliding roof open switch failure signal (Past)

        ON: Sliding roof open switch failure signal (Past)

        		 -
        Close Switch Failure(Past) Close switch failure signal (Past) OFF or ON

        OFF: No sliding roof close switch failure signal (Past)

        ON: Sliding roof close switch failure signal (Past)

        		 -
        Up Switch Failure(Past) Up switch failure signal (Past) OFF or ON

        OFF: No sliding roof tilt up switch failure signal (Past)

        ON: Sliding roof tilt up switch failure signal (Past)

        		 -
        Down Switch Failure(Past) Down switch failure signal (Past) OFF or ON

        OFF: No sliding roof tilt down switch failure signal (Past)

        ON: Sliding roof tilt down switch failure signal (Past)

        		 -
        Open Switch Failure(Current) Open switch failure signal (Current) OFF or ON

        OFF: No sliding roof open switch failure signal (Current)

        ON: Sliding roof open switch failure signal (Current)

        		 -
        Close Switch Failure(Current) Close switch failure signal (Current) OFF or ON

        OFF: No sliding roof close switch failure signal (Current)

        ON: Sliding roof close switch failure signal (Current)

        		 -
        Up Switch Failure(Current) Up switch failure signal (Current) OFF or ON

        OFF: No sliding roof tilt up switch failure signal (Current)

        ON: Sliding roof tilt up switch failure signal (Current)

        		 -
        Down Switch Failure(Current) Down switch failure signal (Current) OFF or ON

        OFF: No sliding roof tilt down switch failure signal (Current)

        ON: Sliding roof tilt down switch failure signal (Current)

        		 -
        Number of Trouble Codes Number of DTCs Min.: 0, Max.: 255 Number of stored DTCs -




























      • *: w/o Canister Pump Module


      1. Body Electrical > Main Body > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        IG SW Engine switch status OFF or ON

        OFF: Engine switch off

        ON: Engine switch on (IG)

        		 "OFF" is displayed even though the engine switch is on (ACC).
        FR Door Courtesy SW Front door courtesy light switch assembly (for RH) signal OFF or ON

        OFF: Front door RH closed

        ON: Front door RH open

        		 -
        FL Door Courtesy SW Front door courtesy light switch assembly (for LH) signal OFF or ON

        OFF: Front door LH closed

        ON: Front door LH open

        		 -
        Door Key P/W Up Door key linked sliding roof close OFF or ON Customize setting displayed -
        Door Key P/W Down Door key linked sliding roof open OFF or ON Customize setting displayed -
        P/W Up W/ Transmit Wireless transmitter linked sliding roof close* OFF or ON Customize setting displayed -
        P/W Down W/ Transmit Wireless transmitter linked sliding roof open* OFF or ON Customize setting displayed -
        Slide Roof Open Warning Sliding roof open warning OFF or ON Customize setting displayed -
        Communication Slide Roof Connection status between sliding roof ECU (sliding roof drive gear sub-assembly) and main body ECU (multiplex network body ECU) STOP or OK

        STOP: Communication stopped

        OK: Normal communication

        		 -











      • *: w/o Canister Pump Module

  2. ACTIVE TEST

    Tip:

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Sliding Roof / Active Test.

    5. Perform the Active Test according to the display on the GTS.


      1. Body Electrical > Sliding Roof > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Slide Roof Operate sliding roof motor OFF / Opn/Dwn / Clos/Up -