Click here

QUARTER WINDOW GLASS REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  2. Click here

    REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  3. Click here

    REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  4. Click here

    REMOVE LAP BELT OUTER ANCHOR COVER

    Click here

  5. Click here

    DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH

    Click here

  6. Click here

    DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

    Click here

  7. Click here

    REMOVE REAR SIDE SEATBACK ASSEMBLY LH

    Click here

  8. Click here

    REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  9. Click here

    REMOVE CENTER PILLAR GARNISH ASSEMBLY LH

    Click here

  10. Click here

    REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  11. Click here

    REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH

    Click here

  12. Click here

    REMOVE ROOF SIDE RAIL WEATHERSTRIP LH

    Click here

  13. Click here

    REMOVE QUARTER WINDOW ASSEMBLY


    1. w/ Glass Breakage Sensor:


      1. B00669W

        Disconnect the connector.

      2. Disengage the clamp and disconnect the wire harness.

    2. B0065WHC01
      B00667M Protective Tape

      Apply protective tape to the area around the installation position of the quarter window assembly on the vehicle body to prevent it from being scratched.

    3. B0066I8C01
      *1 Clip
      *a Piano Wire

      Pass a piano wire between the vehicle body and quarter window assembly from the interior.

      Note:

      Do not pull the piano wire in a vertical direction, but pull it in a horizontal direction.

    4. Tie both wire ends to wooden blocks or similar objects that can serve as handles.

    5. Cut off the adhesive by pulling the piano wire around the quarter window assembly.

      Note:

      When separating the quarter window assembly, be careful not to damage the paint or interior and exterior ornaments.

    6. B0065KA

      Using suction cups, disengage the 3 clips and remove the quarter window assembly.

      Note:

      • Be careful not to drop the quarter window assembly.

      • Be sure to replace the quarter window assembly with a new one.

  14. Click here

    CLEAN VEHICLE BODY


    1. Clean and shape the contact surface of the vehicle body.


      1. B00677JC01
        *a Vehicle Body
        B00667M Adhesive

        Using a knife, cut away excess adhesive on the contact surface of the vehicle body as shown in the illustration.

        Standard Dimension
        Area Dimension
        a 1.0 mm (0.0394 in.) or more
        Note:

        Be careful not to damage the vehicle body.

        Tip:

        Leave approximately 1.0 mm (0.0394 in.) of adhesive on the vehicle body.

    2. Clean the contact surface of the vehicle body with a piece of cloth saturated with non-residue solvent.

      Tip:

      Even if all of the adhesive has been removed, clean the vehicle body.