CAUTION / NOTICE / HINT
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
Temporarily install the power window regulator motor assembly with the bolt.
Temporarily install the housing cap with the 2 bolts.
Tighten the 3 bolts to install the power window regulator motor assembly.
| 5.4 N*m | 55 kgf*cm | 48 in.*lbf |
When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
INSTALL FRONT DOOR UPPER WINDOW STOP
INSPECT FRONT DOOR GLASS SUB-ASSEMBLY
ADJUST FRONT DOOR GLASS SUB-ASSEMBLY
INSTALL FRONT DOOR SERVICE HOLE COVER
INSTALL OUTER MIRROR INSTALL HOLE COVER
INSTALL FRONT DOOR TRIM BRACKET
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION
INSTALL COURTESY LIGHT ASSEMBLY
INSTALL DOOR TRIM COVER
INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
INITIALIZE POWER WINDOW CONTROL SYSTEM
INSPECT POWER WINDOW OPERATION