Click here

ROOF HEADLINING REASSEMBLY

Click here
Click here Click here

PROCEDURE


  1. Click here

    INSTALL NO. 1 ROOF WIRE


    1. B00655WC01
      *A w/o Sliding Roof *B w/ Sliding Roof
      *a Marking - -
      B00667M Butyl Tape - -

      Apply butyl tape as shown in the illustration.

      Note:

      Securely attach butyl tape.

    2. B0065UEC01
      *A w/o Sliding Roof *B w/ Sliding Roof

      Turn the 2 visor connectors clockwise approximately 45° to install them to the roof headlining assembly.

    3. w/o Sliding Roof:


      1. Engage the 6 clamps.

    4. w/ Sliding Roof:


      1. Engage the 11 clamps.

    5. B00686WC02
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/o Lane Departure Alert System without Rain Sensor *D w/o Lane Departure Alert System with Rain Sensor
      *a Marking Tape (A) *b Marking Tape (B)
      *c Marking Tape (C) *d Marking Tape (D)
      *e Adjustment Area - -

      Align the marking tape (A) on the No. 1 roof wire with the vehicle front side tab of the roof headlining assembly.

    6. Align the edge of the marking tape (B) on the No. 1 roof wire with the markings on the roof headlining assembly.

    7. Align the edge of the marking tape (C) on the No. 1 roof wire with the markings on the roof headlining assembly.

    8. Attach the No. 1 roof wire with the butyl tape.

      Note:

      • Securely attach the No. 1 roof wire.

      • If any of the No. 1 roof wire is left loose, it will cause an abnormal noise.

      • Make sure to attach the No. 1 roof wire without leaving any of it loose.

      Tip:

      Secure the extra length of the No. 1 roof wire in the adjustment area.

    9. w/o Lane Departure Alert System without Rain Sensor:


      1. Align the edge of the marking tape (D) on the No. 1 roof wire with the notch on the roof headlining assembly.

    10. w/o Lane Departure Alert System with Rain Sensor:


      1. Align the edge of the 2 marking tapes (D) on the No. 1 roof wire with the notch on the roof headlining assembly.

    11. B00687KC01
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/o Lane Departure Alert System without Rain Sensor *D w/o Lane Departure Alert System with Rain Sensor
      *1 No. 1 Roof Wire - -
      *a Correct *b Incorrect
      *c 15 mm (0.591 in.) or more - -
      B00667M Adhesive Tape - -

      Install the No. 1 roof wire to the roof headlining assembly with adhesive tape.

      Note:

      • Apply the tape securely in place.

      • Do not touch the adhesive surface when applying the tape to prevent adhesion failure.

  2. Click here

    INSTALL COAT HOOK

    Tip:

    Use the same procedure for the RH side and LH side.


    1. B0066HB

      Engage the 6 claws to install the coat hook.

  3. Click here

    INSTALL VANITY LIGHT ASSEMBLY

    Tip:

    Use the same procedure for the RH side and LH side.


    1. B006555C01
      *1 Bulb Holder

      Engage the claw (B) to install the vanity light assembly.

    2. Engage the 2 claws (A) to install the bulb holder to the vanity light assembly.