FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. Click here

   REMOVE FRONT DOOR SCUFF PLATE

   Click here

4. Click here

   REMOVE REAR SEAT CUSHION ASSEMBLY

   Click here

5. Click here

   REMOVE REAR SEAT CUSHION LOCK HOOK

   Click here

6. Click here

   REMOVE LAP BELT OUTER ANCHOR COVER

   
   
   1. 

      Disengage the 2 claws.

   2. Disengage the guide to remove the lap belt outer anchor cover.

7. Click here

   DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

   
   

   1. Remove the nut and disconnect the floor anchor of the front seat outer belt assembly.

8. Click here

   DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

   Click here

9. Click here

   REMOVE REAR SIDE SEATBACK ASSEMBLY

   Click here

10. Click here

    REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

    Click here

11. Click here

    REMOVE CENTER PILLAR GARNISH ASSEMBLY

    Click here

12. Click here

    REMOVE FRONT SEAT OUTER BELT ASSEMBLY

    
    

    1. Remove the bolt and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. 

       *a	Protective Tape
       *b	Locking Button
       *c	Release

       Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

       Tip:

       Tape the screwdriver tip before use.

    3. Disconnect the connector.

    4. 

       Remove the 2 bolts and front seat outer belt assembly.

13. Click here

    REMOVE OUTER BELT ANCHOR BRACKET SUB-ASSEMBLY

    
    
    1. 

       Remove the clip.

    2. Disengage the guide.

    3. Turn back the floor carpet as shown in the illustration.

    4. 

       Remove the bolt.

    5. Disengage the clip to remove the outer belt anchor bracket sub-assembly.