REAR SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. Click here

   REMOVE FRONT DOOR SCUFF PLATE

   Click here

4. Click here

   REMOVE REAR SEAT CUSHION ASSEMBLY

   Click here

5. Click here

   REMOVE REAR SEAT CUSHION LOCK HOOK

   Click here

6. Click here

   DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

   
   
   1. 

      Using a moulding remover, disengage the 3 clips to disconnect the belt guide unit of the rear seat 3 point type outer belt assembly.

   2. 

      Remove the bolt and disconnect the floor anchor of the rear seat 3 point type outer belt assembly.

7. Click here

   REMOVE REAR SIDE SEATBACK ASSEMBLY

   Click here

8. Click here

   REMOVE REAR SEATBACK ASSEMBLY

   Click here

9. Click here

   REMOVE LAP BELT OUTER ANCHOR COVER

   Click here

10. Click here

    DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

    Click here

11. Click here

    REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

    Click here

12. Click here

    REMOVE INNER ROOF SIDE GARNISH ASSEMBLY

    Click here

13. Click here

    REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

    
    

    1. for LH Side:

       
       
       1. 

          *a	Protective Tape
          *b	Locking Button
          *c	Release

          Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

          Tip:

          Tape the screwdriver tip before use.

    2. for RH Side:

       
       
       1. 

          *a	Protective Tape
          *b	Locking Button
          *c	Release

          Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

          Tip:

          Tape the screwdriver tip before use.

    3. 

       Remove the 2 bolts.

    4. Disengage the guide to remove the rear seat 3 point type outer belt assembly.

14. Click here

    REMOVE REAR SEAT OUTER BELT ANCHOR BRACKET ASSEMBLY

    
    
    1. 

       Remove the bolt.

    2. Disengage the guide to remove the rear seat outer belt anchor bracket assembly.