Click here

PRE-COLLISION SYSTEM, Diagnostic DTC:U0100, U0125, U0126, U0129

Click here
Click here
DTC Code DTC Name
U0100 Lost Communication with ECM / PCM "A"
U0125 Lost Communication with Yaw Rate Sensor Module
U0126 Lost Communication with Steering Angle Sensor Module
U0129 Lost Communication with Brake System Control Module
Click here

DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect objects in front of the vehicle. Based on signals from the millimeter wave radar sensor assembly, the driving support ECU assembly sends pre-collision system control operation signals. These DTCs are stored when a communication malfunction occurs between ECUs that perform pre-collision system control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" When the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the ECM and the driving support ECU assembly is detected for approximately 5 seconds. CAN communication system
U0125 Lost Communication with Yaw Rate Sensor Module When the engine switch is on (IG), a communication error between the yaw rate sensor and the driving support ECU is detected for approximately 1 second. CAN communication system
U0126 Lost Communication with Steering Angle Sensor Module When the engine switch is on (IG), a communication error between the steering sensor and the driving support ECU assembly is detected for approximately 4 seconds. CAN communication system
U0129 Lost Communication with Brake System Control Module When the engine switch is on (IG), a communication error between the skid control ECU (brake actuator assembly) and the driving support ECU assembly is detected for approximately 3 seconds. CAN communication system
Click here

PROCEDURE


  1. Click here

    CHECK FOR DTCs (PRE-COLLISION SYSTEM)


    1. Clear the DTCs.

      Click here


      1. Body Electrical > Pre-Collision 2 > Clear DTCs


    2. Perform the following procedure.

      Tip:

      If the following procedure is not performed, the previously output DTC cannot be detected.


      1. Drive the vehicle at a speed of 5 km/h (4 mph) or more for 5 seconds or more.

    3. Check for DTCs.

      Click here


      1. Body Electrical > Pre-Collision 2 > Trouble Codes


      Result
      Result Proceed to
      DTC U0100, U0125, U0126 and U0129 are not output A
      DTC U0100, U0125, U0126 or U0129 is output B