AMBIENT LIGHT INSPECTION

PROCEDURE

1. Click here

   INSPECT NO.1 INTERIOR ILLUMINATION LIGHT ASSEMBLY LH (AMBIENT ILLUMINATION LIGHT ASSEMBLY LH)

   
   
   1. 

      *a	Component without harness connected (Ambient Illumination Light Assembly LH)

      Apply battery voltage to the connector and check that the ambient illumination light LH comes on.

      OK
      Measurement Condition Condition Specified Condition Battery positive (+) → 1 (+) Battery negative (-) → 2 (-) Always Ambient illumination light LH comes on

      If the result is not as specified, replace the ambient illumination light assembly LH.

2. Click here

   INSPECT NO.1 INTERIOR ILLUMINATION LIGHT ASSEMBLY RH (AMBIENT ILLUMINATION LIGHT ASSEMBLY RH)

   
   
   1. 

      *a	Component without harness connected (Ambient Illumination Light Assembly RH)

      Apply battery voltage to the connector and check that the ambient illumination light RH comes on.

      OK
      Measurement Condition Condition Specified Condition Battery positive (+) → 1 (+) Battery negative (-) → 2 (-) Always Ambient illumination light RH comes on

      If the result is not as specified, replace the ambient illumination light assembly RH.