Click here

IMMOBILISER SYSTEM, Diagnostic DTC:B279C

Click here
Click here
DTC Code DTC Name
B279C Theft Deterrent System Presence Detection
Click here

DESCRIPTION

If an ECM that is incompatible with the immobiliser system is installed, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B279C Theft Deterrent System Presence Detection An ECM that is incompatible with the immobiliser system is installed. (1-trip detection logic*) ECM -

Table 1. Vehicle Condition and Fail-safe Function when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
Engine cannot be started -
Table 2. Related Data List and Active Test
DTC No. Data List and Active Test
B279C -
Click here

CAUTION / NOTICE / HINT

Note:
  • When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • Before replacing the ECM refer to Service Bulletin.

  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

Click here

PROCEDURE


  1. Click here

    REPLACE ECM


    1. Temporarily replace the ECM with a new one.

      Click here

      Result
      Proceed to
      NEXT

  2. Click here

    REGISTER ECU COMMUNICATION ID


    1. Register the ECU communication ID.

      Tip:

      Refer to Service Bulletin.

      Result
      Proceed to
      NEXT

  3. Click here

    CLEAR DTC


    1. Clear the DTCs.


      1. Powertrain > Engine > Clear DTCs


      Result
      Proceed to
      NEXT

  4. Click here

    CHECK FOR DTC


    1. Check for DTCs.


      1. Powertrain > Engine > Trouble Codes


      OK
      B279C is not output.
      Result
      Result Proceed to
      DTC B279C is not output A
      DTC B279C is output B

    • A

      END (ECM WAS DEFECTIVE)

    • B

      USE SIMULATION METHOD TO CHECKClick here