ENTRY AND START SYSTEM(for Start Function) PRECAUTION


  1. CAUTION REGARDING INTERFERENCE WITH ELECTRONIC DEVICES

    CAUTION:


    • People with implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverter defibrillators should keep away from the entry and start system antennas. The emitted radio waves may affect the operation of such devices. If necessary, the entry function can be disabled. Ask your dealer for details, such as the frequency and timing of the emitted radio waves. Then, consult your doctor to see if you should disable the entry function.

      Click here

    • Users of any electrical medical device other than implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverter defibrillators should consult the manufacturer of the device for information about its operation under the influence of radio waves. Radio waves could have unexpected effects on the operation of such medical devices.

    • Ask your dealer for details for disabling the entry function.

  2. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

    System Name See Procedure
    Parking Assist Monitor System (w/ Parallel Parking Assist Function)

    Click here

    Parking Assist Monitor System (w/o Parallel Parking Assist Function)
    Air Conditioning System

  3. DOOR CONTROL RECEIVER EXPRESSIONS


    1. The type of door control receiver used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Vehicle Specification Part Name in Manual Actual Part Name
      for 12 Pin Type Door control receiver Door control and tire pressure monitoring system receiver assembly
      for 5 Pin Type Door control receiver Door control receiver

  4. PRECAUTION WHEN USING GTS


    1. When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  5. PRECAUTION FOR REGISTRATION


    1. If replacing any of the following parts, refer to Service Bulletin.


      1. Certification ECU (smart key ECU assembly)

      2. Steering lock ECU (steering lock actuator assembly)

      3. ECM

      4. Electrical key transmitter sub-assembly

      5. ID code box (immobiliser code ECU)

      6. Main body ECU (multiplex network body ECU)

    2. When the certification ECU (smart key ECU assembly) is replaced, the stored steering lock position will no longer match that of the steering lock ECU (steering lock actuator assembly) and it may not be possible to start the engine. Therefore, after replacement, perform the following procedure.


      1. Move the shift lever to P.

      2. With the engine switch off, open and close a door, and then start the engine.