Click here

NETWORK GATEWAY ECU REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Note:

  • When disassembling the network gateway ECU, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.

  • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  2. Click here

    REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)

    Click here

  3. Click here

    REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for RHD)

    Click here

  4. Click here

    REMOVE FRONT NO. 2 CONSOLE BOX INSERT (for LHD)

    Click here

  5. Click here

    REMOVE FRONT NO. 1 CONSOLE BOX INSERT (for RHD)

    Click here

  6. Click here

    REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  7. Click here

    REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  8. Click here

    REMOVE NETWORK GATEWAY ECU


    1. B0065SD

      Disconnect the network gateway ECU connector.

    2. Remove the 2 bolts and network gateway ECU from the blower assembly.