SIDE AIRBAG SENSOR(for Rear Side) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL SIDE AIRBAG SENSOR ASSEMBLY

   
   

   1. Check that the engine switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. 

      *a

      Correct

      *b

      Incorrect

      Before connecting the connector, check that the position of the white housing lock is as shown in the illustration.

   4. Insert the side airbag sensor assembly pin (stopper) into the body hole and install the side airbag sensor assembly to the vehicle body with the bolt.

      9.0 N*m

      92 kgf*cm

      80 in.*lbf

      Note:
      

      • If the side airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the side airbag sensor assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the side airbag sensor assembly pin (stopper) is securely inserted into the body hole.

      • Tighten the bolt while holding the side airbag sensor assembly because the side airbag sensor assembly pin (stopper) is easily damaged.

   5. 

      *a

      White Housing Lock

      *b

      Engage

      Connect the connector to the side airbag sensor assembly.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      Tip:
      

      • Be sure to connect the connector until it is locked (when locking, make sure that a click sound can be heard).

      • When the connector is locked, the white housing lock will slide. Be sure not to hold the white housing lock or the part (A) as it may result in an insecure connection.

   6. Check that there is no looseness in the installed parts of the side airbag sensor assembly.

2. Click here

   INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY

   Click here

3. Click here

   INSTALL FRONT DOOR SCUFF PLATE

   Click here

4. Click here

   INSTALL REAR SIDE SEATBACK ASSEMBLY

   Click here

5. Click here

   CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

   Click here

6. Click here

   INSTALL REAR SEAT CUSHION LOCK HOOK

   Click here

7. Click here

   INSTALL REAR SEAT CUSHION ASSEMBLY

   Click here

8. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

9. Click here

   PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here

10. Click here

    INSPECT SRS WARNING LIGHT

    Click here