In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
DATA LIST
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Central Gateway / Data List.
| Tester Display |
|---|
| IG2 SW |
| IG1 SW |
| ACC SW |
| +B Voltage |
| Number of DTC |
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition |
|---|---|---|---|
| IG2 SW | Engine switch on (IG) signal (IG2 terminal) | OFF or ON | OFF: Engine switch on (ACC) or off ON: Engine switch on (IG) |
| IG1 SW | Engine switch on (IG) signal (IG1 terminal) | OFF or ON | OFF: Engine switch on (ACC) or off ON: Engine switch on (IG) |
| ACC SW | Engine switch on (ACC) signal (ACC terminal) | OFF or ON | OFF: Engine switch off ON: Engine switch on (ACC) or on (IG) |
| +B Voltage | Battery voltage (BATT terminal) | Over 8 V or Under 8 V | Over 8 V: Battery voltage 8 V or higher Under 8 V: Battery voltage below 8 V |
| Number of DTC | Number of DTCs | 0 to 255 | 0: Normal |