GENERATOR INSTALLATION

PROCEDURE

1. INSTALL GENERATOR ASSEMBLY

   
   

   1. Using an E8 "TORX" socket wrench, temporarily install the generator assembly with the 2 stud bolts.

   2. Tighten the 2 stud bolts.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

   3. Install the generator assembly and engine wire bracket with the 2 bolts and 2 nuts.

      Torque:

      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

   4. Connect the oil cooler tube with the bolts.

      Torque:

      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

   5. Connect the generator assembly connector.

   6. Connect the engine wire to terminal B with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   7. Close the terminal cap.

   8. Connect the engine wire with the bolt.

      Torque:

      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

   9. Engage the clamp.

2. INSTALL V-RIBBED BELT

   Click here

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here