ULTRASONIC SENSOR(for Rear Side) INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 ULTRASONIC SENSOR

  2. INSTALL ULTRASONIC SENSOR CLIP


    1. A01FNSD

      Engage the claw to install the ultrasonic sensor clip.

      Tech Tips

      Use the same procedure for all ultrasonic sensor clips.

  3. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Perform this step only when necessary.

    • If a No. 1 ultrasonic sensor retainer has been removed, replace it with a new one. Install the ultrasonic sensor with clip with a new No. 1 ultrasonic sensor retainer as a set.

    • Use the same procedure for all No. 1 ultrasonic sensor retainers.


    1. A01FLJM

      Engage the 2 claws and install a new No. 1 ultrasonic sensor retainer to the ultrasonic sensor with clip.

    2. Clean the rear bumper cover surface.


      1. Remove any remaining double-sided tape from the rear bumper cover.

      2. Wipe off any tape adhesive residue with cleaner.

    3. A01FKVMC01
      B0065WB Primer

      Using a brush or felt, apply primer or equivalent to the No. 1 ultrasonic sensor retainer installation area.

      Note


      • Use a clean brush or felt.

      • Do not touch the rear bumper assembly until the primer has dried.

    4. Peel off the release paper from the new No. 1 ultrasonic sensor retainer.

    5. A01FO8YC01
      *a Protrusion of the mark

      Align the No. 1 ultrasonic sensor retainer with ultrasonic sensor with the mark on the rear bumper cover and install it as shown in the illustration.

      Note

      The double-sided tape of a No. 1 ultrasonic sensor retainer will deteriorate if it is detached. Make sure to replace the No. 1 ultrasonic sensor retainer with a new one when reattachment is necessary.

      Tech Tips


      • Align the connector with the protrusion of the mark when connecting it.

      • To ensure that the No. 1 ultrasonic sensor retainer is securely installed to the rear bumper cover, press on the areas shown in the illustration with a force of 30 N (3.0 kgf) for 3 seconds.

  4. INSTALL ULTRASONIC SENSOR WITH CLIP


    1. Engage the 2 claws to install the ultrasonic sensor with clip.

    2. Engage the clamp.

    3. Connect the connector.

  5. INSTALL REAR BUMPER ASSEMBLY

    Click here