Click here

BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1ABB

Click here
Click here
DTC Code DTC Name
C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete
Click here

DESCRIPTION

This DTC is stored when a beam axis adjustment has not been performed for the blind spot monitor sensor LH.

Tip:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis adjustment is performed. Completing the beam axis adjustment after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete A beam axis adjustment has not been performed Blind spot monitor sensor LH
Click here

PROCEDURE


  1. Click here

    PERFORM BLIND SPOT MONITOR BEAM AXIS ADJUSTMENT


    1. Perform the Blind Spot Monitor Beam Axis Adjustment using the GTS.


      1. Body Electrical > Blind Spot Monitor Master > Utility
        Tester Display
        BSM Master Beam Axis Adjustment




      Tip:

      Refer to Blind Spot Monitor Beam Axis Confirmation.

      Click here

      Result
      Proceed to
      NEXT

    • NEXT

      END