BLIND SPOT MONITOR SYSTEM CUSTOMIZE PARAMETERS


  1. CUSTOMIZE BLIND SPOT MONITOR SYSTEM


    1. Customizing with the GTS

      Note


      • When the customer requests a change in a function, first make sure that the function can be customized.

      • Be sure to make a note of the current settings before customizing.

      • When troubleshooting a function, first make sure that the function is set to the default setting.


      1. Connect the GTS to the DLC3.

      2. Turn the engine switch on (IG).

      3. Turn the blind spot monitor main switch (warning canceling switch assembly) on.

      4. Turn the GTS on.

      5. Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / Warning.

      6. Select the setting by referring to the table below.


        Warning
        Tester Display Description Default Setting ECU
        RCTA Function Switches the RCTA function on and off. ON 0:ON,1:OFF Blind Spot Monitor Sensor RH
        BSM Approaching Vehicle Detection Timing Setting Sets the notification timing for vehicles approaching from behind the vehicle. Middle 00:Only Blind Spot,01:Late,10:Middle,11:Early Blind Spot Monitor Sensor LH