Click here

PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function) Reverse Signal Circuit

Click here
Click here
DTC Code DTC Name
  Reverse Signal Circuit
Click here

DESCRIPTION

The multi-display assembly receives a reverse signal from the park/neutral position switch assembly.

Table 1. *a REV *b Park/Neutral Position Switch Assembly *c Multi-display Assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here

  • When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

Click here

PROCEDURE


  1. Click here

    INSPECT MULTI-DISPLAY ASSEMBLY (REV)


    1. B0067BOC09
      *a

      Component with harness connected

      (Multi-display Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      O60-3 (REV) - Body ground Engine switch on (IG), shift lever in R 9 to 16 V
      Engine switch on (IG), shift lever not in R Below 2 V
      Result
      Proceed to
      OK
      NG

  2. Click here

    INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Click here

    Result
    Proceed to
    OK
    NG

    • OK

      REPAIR OR REPLACE HARNESS OR CONNECTOR

    • NG

      REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLYClick here