PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function) Black Screen

DESCRIPTION

The video signal from the rear television camera assembly is transmitted to the multi-display assembly .

WIRING DIAGRAM

B0067B9E05

CAUTION / NOTICE / HINT

Note


  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here

  • When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY ASSEMBLY - LUGGAGE ELECTRICAL KEY SWITCH)

    Click here

    Result
    Proceed to
    OK
    NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT LUGGAGE ELECTRICAL KEY SWITCH

    Click here

    Result
    Proceed to
    OK
    NG

    NG

    REPLACE LUGGAGE ELECTRICAL KEY SWITCH Click here

    OK

  3. INSPECT MULTI-DISPLAY ASSEMBLY (CA+, CGND)

    Click here

    Result
    Proceed to
    OK
    NG

    NG

    REPLACE MULTI-DISPLAY ASSEMBLY Click here

    OK

  4. INSPECT MULTI-DISPLAY ASSEMBLY (V+, CGND)

    Click here

    Result
    Proceed to
    OK
    NG

    NG

    REPLACE LUGGAGE ELECTRICAL KEY SWITCH WITH REAR TELEVISION CAMERA ASSEMBLY Click here

    OK

  5. REPLACE MULTI-DISPLAY ASSEMBLY


    1. Replace the multi-display assembly with a new or known good one.

      Click here

    2. Check that the parking assist monitor system operates normally.

      OK
      Parking assist monitor system operates normally.
      Result
      Proceed to
      OK
      NG

    OK

    END (MULTI-DISPLAY ASSEMBLY WAS DEFECTIVE)

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here