Click here

PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function) Black Screen

Click here
Click here
DTC Code DTC Name
  Black Screen
Click here

DESCRIPTION

The video signal from the rear television camera assembly is transmitted to the radio receiver assembly.

Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - RADIO RECEIVER ASSEMBLY)

    Click here

    Result
    Proceed to
    OK
    NG

    • OKClick here
    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR

  2. Click here

    INSPECT RADIO RECEIVER ASSEMBLY (CA+, CGND)

    Click here

    Result
    Proceed to
    OK
    NG

  3. Click here

    INSPECT RADIO RECEIVER ASSEMBLY (V+, GND1)

    Click here

    Result
    Proceed to
    OK
    NG

  4. Click here

    REPLACE RADIO RECEIVER ASSEMBLY


    1. Replace the radio receiver assembly with a new or known good one.

      Click here

    2. Check that the parking assist monitor system operates normally.

      OK
      Parking assist monitor system operates normally.
      Result
      Proceed to
      OK
      NG

    • OK

      END

    • NG

      REPLACE REAR TELEVISION CAMERA ASSEMBLYClick here