PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / IPA/Parking Assist Monitor / Data List.

    5. Read the Data List according to the display on the GTS.


    Chassis > IPA/Parking Assist Monitor > Data List
    Tester Display Measurement Item Range Normal Condition Diagnostic Note
    Video Output Status Output condition of video signal OK or NG

    OK: Output condition of video signal is normal

    NG: Output condition of video signal is abnormal

    -
    2WD/4WD Data Check Verification of 2WD/4WD data OK or NG

    OK: Data verification normal

    NG: Data verification abnormal

    -
    Destination Data Check Verification of destination data OK or NG

    OK: Data verification normal

    NG: Data verification abnormal

    -
    RHD/LHD Signal Check Verification of RHD/LHD signal OK or NG

    OK: Output condition of RHD/LHD signal is normal

    NG: Output condition of RHD/LHD signal is abnormal

    -
    VGRS With or Without Status (Back Camera) Verification of whether the internal data of the rear television camera assembly matches the input "with/without VGRS" data. OK or NG

    OK: Data verification normal

    NG: Data verification abnormal

    -
    EEPROM Status (Initial read) Rear television camera assembly information OK or NG

    OK: Rear television camera assembly normal

    NG: Rear television camera assembly abnormal

    -
    CPU Communication Status Rear television camera assembly information OK or NG

    OK: Rear television camera assembly normal

    NG: Rear television camera assembly abnormal

    -
    VGRS Relative Angle Status VGRS relative angle signal from VGRS ECU (front steering control ECU) status OK or NG

    OK: VGRS relative angle signal normal

    NG: VGRS relative angle signal abnormal

    -
    Number of DTC Number of stored DTCs min.: 0, max.: 255 Number of DTCs will be displayed -
    Current Key Cycle Cumulative number of times the engine switch was turned on (IG) Min.: 0, Max.: 65535 time Cumulative number of times the engine switch was turned on (IG) will be displayed -
    Current Key Cycle Elapsed Time Time elapsed since the engine switch was turned on (IG) Min.: 0, Max.: 1677721.5 s Time elapsed since the engine switch was turned on (IG) will be displayed -