Click here

PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function), Diagnostic DTC:C1622

Click here
Click here
DTC Code DTC Name
C1622 Back Camera Disconnected
Click here

DESCRIPTION

This DTC is stored if the radio receiver assembly judges that the signals or signal lines between the radio receiver assembly and the rear television camera assembly are not normal as a result of its self check.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1622 Open or Short Circuit in Back Camera Signal Open or short in the rear television camera assembly signal circuit

  • Harness or connector

  • Luggage electrical key switch

  • Rear television camera assembly

  • Radio receiver assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - LUGGAGE ELECTRICAL KEY SWITCH)


    1. Disconnect the O57 radio receiver assembly connector.

    2. Disconnect the U40 luggage electrical key switch connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O57-39 (CA+) - U40-6 (CB+) Always Below 1 Ω
      O57-18 (V+) - U40-3 (CV+) Always Below 1 Ω
      O57-19 (V-) - U40-2 (CV-) Always Below 1 Ω
      O57-40 (CGND) - U40-5 (CGND) Always Below 1 Ω
      O57-39 (CA+) - Body ground Always 10 kΩ or higher
      O57-18 (V+) - Body ground Always 10 kΩ or higher
      O57-19 (V-) - Body ground Always 10 kΩ or higher
      O57-40 (CGND) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    • OKClick here
    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR

  2. Click here

    INSPECT LUGGAGE ELECTRICAL KEY SWITCH


    1. Disconnect the A rear television camera assembly connector.

    2. Inspect the luggage electrical key switch.

      Click here

      Result
      Proceed to
      OK
      NG

  3. Click here

    INSPECT RADIO RECEIVER ASSEMBLY (CA+, CGND)


    1. Reconnect the O57 radio receiver assembly connector.

    2. B006790C38
      *a

      Component with harness connected

      (Radio Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O57-40 (CGND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      O57-39 (CA+) - O57-40 (CGND) Engine switch on (ACC) 5.5 to 7.05 V
      Result
      Proceed to
      OK
      NG

  4. Click here

    INSPECT RADIO RECEIVER ASSEMBLY (V+, GND1)


    1. Reconnect the U40 luggage electrical key switch connector.

    2. Reconnect the A rear television camera assembly connector.

    3. B00674KC05
      *a Waveform 1 (camera lens is not covered, displaying an image)
      *b Waveform 2 (camera lens is covered, blacking out the screen)
      *c Synchronization Signal
      *d Video Waveform
      B006790C39
      *a

      Component with harness connected

      (Radio Receiver Assembly)

      Using an oscilloscope, check the waveform of the rear television camera assembly.

      Tip:

      A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio receiver assembly with the connector connected.

      OK
      Waveform is similar to that shown in the illustration.
      Item Content
      Measurement terminal O57-18 (V+) - O57-12 (GND1)
      Measurement setting 200 mV/DIV., 50 μs./DIV.
      Condition Engine switch on (IG), shift lever in R
      Tip:

      The video waveform changes according to the image sent by the rear television camera assembly.

      Result
      Proceed to
      OK
      NG

    • OK

      REPLACE RADIO RECEIVER ASSEMBLY w/ Navigation System:Click here

      REPLACE RADIO RECEIVER ASSEMBLY w/o Navigation System:Click here

    • NG

      REPLACE REAR TELEVISION CAMERA ASSEMBLYClick here