Click here

FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL

Click here
Click here Click here

PROCEDURE


  1. Click here

    PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    Note:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. Click here

    REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT

    Click here

  3. Click here

    DISCONNECT NO. 2 INSTRUMENT PANEL WIRE


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B0066FPC01
      *a Slider

      Slide the slider to release the lock, and then disconnect the connector.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  4. Click here

    REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

    Click here

  5. Click here

    REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

    CAUTION:

    When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


    1. B0065I2

      Remove the 2 screws.

    2. B0067RO

      Lean the instrument panel safety pad sub-assembly and disengage the 3 hooks.

    3. B0065I9

      Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad sub-assembly.

  6. Click here

    REMOVE NO. 2 INSTRUMENT PANEL WIRE


    1. B0066M4C01
      *a Protective Tape
      *b Airbag Connector
      *c Airbag Connector Lock

      Disengage the clamp.

    2. Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.

    3. Disconnect the 2 airbag connectors to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.