Click here

CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

Click here
Click here Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

    Note:

    When installing a curtain shield airbag assembly, have assistants hold it to prevent it from bending.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B0067LOC01
      *a Airbag Connector
      *b Airbag Connector Lock

      Connect the airbag connector.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    4. Push in the airbag connector lock to install the airbag connector.

    5. B0065QYC01
      *1 Pin *2 Spacer
      *a Clip (A) *b Spacer Location
      *c Hook - -

      Insert the 2 hooks, install 5 new bolts, 5 new clips (A) with pins and the 2 spacers, and engage 3 clips (B) in the order shown in the illustration to install the curtain shield airbag assembly.

      11 N*m 112 kgf*cm 8 ft.*lbf
      Note:

      Do not twist the curtain shield airbag assembly when installing it.

      Tip:

      Engage the 2 claws to install each new clip (A).

    6. Using needle nose pliers, push the 5 pins into the 5 clips (A).

      Note:

      Make sure that the pins of the clips (A) are pushed in firmly.

  2. Click here

    INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. Click here

    PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here