KNEE AIRBAG ASSEMBLY(for Driver Side) INSTALLATION

PROCEDURE

1. Click here

   INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   
   

   1. Check that the engine switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. 

      *a	Airbag Connector
      *b	Airbag Connector Lock
      *c	DLC3

      Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

   4. Push in the airbag connector lock to install the airbag connector.

   5. Engage the 2 claws to connect the DLC3.

   6. Engage the 2 pins and clamp to temporarily install the lower No. 1 instrument panel airbag assembly.

   7. Install the 4 bolts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

      Note:

      Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

2. Click here

   INSTALL SKID CONTROL BUZZER (w/ Pre-crash Safety System)

   Click here

3. Click here

   INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

   Click here

4. Click here

   CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

5. Click here

   INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

6. Click here

   INSTALL INSTRUMENT SIDE PANEL LH

   Click here

7. Click here

   INSTALL FRONT DOOR OPENING TRIM COVER LH

   Click here

8. Click here

   INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

9. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

10. Click here

    PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

11. Click here

    INSPECT SRS WARNING LIGHT

    Click here