FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

PROCEDURE

1. Click here

   INSTALL NO. 2 INSTRUMENT PANEL WIRE

   
   
   1. 

      *a	Airbag Connector
      *b	Airbag Connector Lock

      Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.

      Note:
      

      • When connecting any airbag connector, take care not to damage the airbag wire harness.

      • Be sure to connect the connectors to each corresponding color.

   2. Push in the 2 airbag connector locks to install the 2 airbag connectors to the instrument panel passenger airbag assembly.

   3. Engage the clamp.

2. Click here

   INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

   
   

   1. Engage the 3 hooks.

   2. Push in the instrument panel passenger airbag assembly to engage the 3 hooks.

   3. Install the instrument panel passenger airbag assembly with the 2 screws.

3. Click here

   INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

   Click here

4. Click here

   CONNECT NO. 2 INSTRUMENT PANEL WIRE

   
   

   1. Check that the engine switch is off.

   2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. 

      Connect the connector.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

5. Click here

   INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT

   Click here