Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
DATA LIST FOR AIRBAG ECU ASSEMBLY
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / SRS Airbag / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Driver Seat Position | Driver Seat Position | Forward: Seat position is forward Bkward: Seat position is backward Fail: Failure is detected |
Forward/Bkward | - |
| Left side Buckle SW | Driver Side Buckle SW | Unset: Seat belt is not fastened Set: Seat belt is fastened NG: Data is not determined |
Unset/Set | for LHD |
| Right side Buckle SW | Driver Side Buckle SW | Unset: Seat belt is not fastened Set: Seat belt is fastened NG: Data is not determined |
Unset/Set | for RHD |
| Display Type Information | Display Type Information | LR: Display is indicated by LH/RH DP: Display is indicated by Driver/Passenger |
LR | - |
| Number of Past DTC | Number of Past DTC | Min.: 0, Max.: 255 | 0 | - |