METER / GAUGE SYSTEM ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT COMBINATION METER ASSEMBLY


    1. Check speedometer operation

      Note


      • The combination meter assembly receives the vehicle speed signal from the brake actuator assembly (skid control ECU) via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the brake actuator assembly (skid control ECU) because it is the source of the vehicle speed signal.

      • Data List values of the brake actuator assembly (skid control ECU) are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.

      • If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.


      1. Warm up the engine.

      2. Connect the GTS to the DLC3.

      3. Turn the engine switch on (IG).

      4. Turn the GTS on.

      5. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

      6. Read the Data List according to the display on the GTS.


        Chassis > ABS/VSC/TRC > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations

        Chassis > ABS/VSC/TRAC > Data List
        Tester Display
        Vehicle Speed

        • for Gauge speedometer

          Reference mph
          GTS Indication (mph) Acceptable Range (mph)
          20 21.0 to 23.5
          40 42.0 to 44.5
          60 62.5 to 66.0
          80 83.1 to 87.1
          100 103.9 to 108.4
          120 124.7 to 129.6
          140 145.4 to 150.7
          160 166.2 to 171.9
          180 187.0 to 193.0
          200 207.8 to 214.2
          Reference km/h (for Fuel Receiver Gauge Scale E to F Type without Telematics Transceiver)
          GTS Indication (km/h) Acceptable Range (km/h)
          20 20.7 to 24.7
          40 41.4 to 45.9
          60 62.1 to 66.6
          80 82.8 to 87.8
          100 103.4 to 107.4
          120 124.1 to 129.1
          140 144.8 to 149.8
          160 165.5 to 170.5
          180 186.2 to 191.2
          200 206.9 to 211.9
          220 227.6 to 232.6
          240 248.3 to 253.3
          260 268.9 to 273.9
          280 289.8 to 294.6
          300 310.3 to 315.3
          320 331.0 to 336.0
          Reference km/h (for Fuel Receiver Gauge Scale R to 1/1 Type, E to F Type with Telematics Transceiver)
          GTS Indication (km/h) Acceptable Range (km/h)
          20 21.0 to 25.0
          40 41.7 to 46.2
          60 62.7 to 67.2
          80 83.4 to 88.4
          100 104.3 to 109.3
          120 125.1 to 130.6
          140 145.8 to 151.8
          160 166.2 to 173.2
          180 186.9 to 194.5
          200 207.7 to 215.7
          220 228.4 to 236.8
          240 249.2 to 258.0
          260 270.0 to 279.2
          280 290.6 to 300.4
          300 311.4 to 321.6
          320 332.2 to 342.8

        • for Digital speedometer

          Reference mph
          GTS Indication (mph) Acceptable Range (mph)
          20 21 to 23
          40 42 to 44
          60 63 to 66
          80 83 to 87
          100 104 to 108
          120 125 to 129
          140 146 to 150
          160 166 to 171
          180 187 to 192
          200 208 to 213
          Reference km/h (for Fuel Receiver Gauge Scale E to F Type without Telematics Transceiver)
          GTS Indication (km/h) Acceptable Range (km/h)
          20 21 to 25
          40 41 to 46
          60 62 to 67
          80 83 to 88
          100 103 to 107
          120 124 to 129
          140 145 to 150
          160 166 to 171
          180 186 to 191
          200 207 to 212
          220 228 to 233
          240 248 to 253
          260 269 to 274
          280 290 to 295
          300 310 to 315
          320 331 to 336
          Reference km/h (for Fuel Receiver Gauge Scale R to 1/1 Type, E to F Type with Telematics Transceiver)
          GTS Indication (km/h) Acceptable Range (km/h)
          20 21 to 25
          40 42 to 46
          60 63 to 67
          80 84 to 88
          100 104 to 109
          120 125 to 130
          140 146 to 151
          160 167 to 173
          180 187 to 194
          200 208 to 215
          220 229 to 236
          240 249 to 257
          260 270 to 278
          280 291 to 299
          300 311 to 321
          320 332 to 342
        OK
        Speedometer reading is within the acceptable range at each vehicle speed.

    2. Inspect tachometer


      1. Warm up the engine.

      2. Connect the GTS to the DLC3.

      3. Turn the engine switch on (IG).

      4. Turn the GTS on.

      5. Enter the following menus: Powertrain / Engine / Data List.

      6. Read the Data List according to the display on the GTS.


        Powertrain > Engine > Data List
        Tester Display Measurement Item Range Normal Condition Reference Value Diagnostic Note
        Engine Speed Engine speed Min.: 0 rpm, Max.: 16383 rpm 700 to 800 rpm: Idling with warm engine Idling (engine warmed up and A/C off): 763 rpm When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.

        Powertrain > Engine > Data List
        Tester Display
        Engine Speed
        Reference
        GTS Indication (rpm)

        Acceptable Range (rpm)

        Data in ( ) is for Reference
        700 630 to 770
        1000 (900 to 1100)
        2000 (1850 to 2150)
        3000 2800 to 3200
        4000 (3800 to 4200)
        5000 4800 to 5200
        6000 (5750 to 6250)
        7000 6700 to 7300
        OK
        Tachometer reading is within the acceptable range at each engine speed.

    3. Check LED illumination (LED check)


      1. Check the illumination function of the warning or indicator lights listed below when turning the engine switch on (IG).

        OK
        Warning or Indicator Light Specified Condition
        Brake warning light Warning or indicator light comes on for about 3 seconds after turning the engine switch on (IG).
        VSC OFF indicator light
        Slip indicator light
        ABS warning light
        Tire pressure warning light*
        Headlight leveling warning light
        Eco driving indicator light
        Master warning light
        TRC OFF indicator light
        SRS warning light Warning light comes on for about 6 seconds after turning the engine switch on (IG).
        Charge warning light Warning light comes on when the engine switch is on (IG).
        MIL (Check engine warning light)
        EPS warning light

        • *: w/ Tire Pressure Warning System