Click here

NAVIGATION SYSTEM Voice Guidance does not Function

Click here
Click here
DTC Code DTC Name
  Voice Guidance does not Function
Table 1. *1 Navigation ECU *2 Radio Receiver Assembly
Click here

WIRING DIAGRAM

Click here

PROCEDURE


  1. Click here

    CHECK VOICE GUIDANCE SETTING


    1. Check that the voice guidance settings are not off.

      OK
      Voice guidance settings are not off.
      Result
      Proceed to
      OK
      NG

    • OKClick here
    • NG

      CHANGE VOICE GUIDANCE SETTINGS TO ON

  2. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU)


    1. Disconnect the O148 radio receiver assembly connector.

    2. Disconnect the O150 navigation ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O148-22 (SI+) - O150-6 (VOI+) Always Below 1 Ω
      O148-23 (SI-) - O150-7 (VOI-) Always Below 1 Ω
      O148-22 (SI+) or O150-6 (VOI+) - Body ground Always 10 kΩ or higher
      O148-23 (SI-) or O150-7 (VOI-) - Body ground Always 10 kΩ or higher
      O150-8 (SLD1) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR