Click here

NAVIGATION SYSTEM, Diagnostic DTC:B158F

Click here
Click here
DTC Code DTC Name
B158F AV Signal Stoppage (Low Battery Voltage)
Click here

DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio receiver assembly dropping temporarily.

DTC No. Detection Item DTC Detection Condition Trouble Area
B158F AV Signal Stoppage (Low Battery Voltage) A video or audio signal is interrupted when the battery voltage drops

  • Radio receiver assembly

  • Harness or connector
Table 1. *a from Battery *b RADIO NO. 2 *c Radio Receiver Assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • Inspect the fuses for circuits related to this system before performing the following procedure.

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

    Click here

  • When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:


    • A communication malfunction DTC may be stored.

    • The radio receiver assembly may not operate normally.

Click here

PROCEDURE


  1. Click here

    CHECK VEHICLE SIGNAL (OPERATION CHECK)


    1. B0066DO

      Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check.

      Click here

    2. Measure the battery voltage.

      Standard Voltage
      11 to 14 V
      Tip:

      This display is updated once per second.

      Result
      Proceed to
      OK
      NG

  2. Click here

    CHECK DTC


    1. Clear the DTCs.


      1. Body Electrical > Navigation System > Clear DTCs


    2. Recheck for DTCs and check that no DTCs are output.


      1. Body Electrical > Navigation System > Trouble Codes


      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    • OK

      END

    • NG

      REPLACE RADIO RECEIVER ASSEMBLYClick here

  3. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE)


    1. Disconnect the O146 radio receiver assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      O146-4 (+B1) - Body ground Always 11 to 14 V
      Result
      Proceed to
      OK
      NG

    • OK

      REPLACE RADIO RECEIVER ASSEMBLYClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR