Click here

NOISE FILTER INSTALLATION

Click here
Click here

PROCEDURE


  1. Click here

    INSTALL RADIO SETTING CONDENSER (for Window Defogger)


    1. B0067RX

      Engage the claw to install a new terminal cover to the wire harness.

      Note:

      • Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

      • Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

      • Do not use excessive force when inserting the wire harness into the terminal cover.

      • If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.

    2. B0067CD

      Engage the 3 claws to install the new terminal cover with wire harness to a new condenser.

      Note:

      • Do not use excessive force when inserting the terminal cover into the condenser.

      • If the terminal cover has been deformed during installation, replace the terminal, terminal cover and condenser with new ones.

    3. Engage the clamp to temporarily install a new radio setting condenser with wire harness.

    4. Install the new radio setting condenser with the bolt.

      8.0 N*m 82 kgf*cm 71 in.*lbf
  2. Click here

    INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH (for Window Defogger)

    Click here

  3. Click here

    INSTALL RADIO SETTING CONDENSER (for High Mounted Stop Light)


    1. B00660B

      Engage the claw to install a new terminal cover to the wire harness.

      Note:

      • Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

      • Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

      • Do not use excessive force when inserting the wire harness into the terminal cover.

      • If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.

    2. B0065RF

      Engage the 6 claws to install 2 new terminal covers with wire harness to a new condenser.

      Note:

      • Do not use excessive force when inserting the terminal covers into the condenser.

      • If a terminal cover has been deformed during installation, replace the terminal, terminal covers and condenser with new ones.

    3. B0065ES

      Insert the cover as shown in the illustration and engage the claw.

    4. Engage the clamp to temporarily install the new radio setting condenser with wire harness.

    5. Install the new radio setting condenser with the bolt.

      8.0 N*m 82 kgf*cm 71 in.*lbf
  4. Click here

    INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  5. Click here

    INSTALL REAR SIDE SEATBACK ASSEMBLY LH

    Click here

  6. Click here

    CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

    Click here

  7. Click here

    INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

  8. Click here

    INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

  9. Click here

    INSTALL FRONT DOOR SCUFF PLATE LH

    Click here